The Orion-Tr Smart DC-DC charger is a professional DC to DC adaptive 3-stage charger with built-in Bluetooth.

For use in dual battery systems in vehicles or on boats where the (smart) alternator and the start battery are used to charge the service battery. The unit can be monitored and programmed via Bluetooth and can be remotely controlled via a remote on/off switch and has an engine running detection mechanism.

The Orion Tr-Smart charger can be used in 12V or 24V systems and is suitable for both lead acid and lithium batteries. Models are available up to 400W and unlimited multiple units can be connected in parallel to increase output power.

Suitable for high temperatures up to 55°C with a full rated output up to 40°C



You will be supplied with



1 x Victron Orion 12v 30amp Non isolated Charger

16mm² 110amp Red Cable

16mm² 110amp Black Cable

5mtrs 1.5mm² 15amp Red Cable ( Option Ignition Switch Feed)

13mm Split Conduit

2 x Midi Fuse Holders + recommended midi fuses including spares

1 x Pair 8mm Post Type Battery Terminals

Crimp Teminals

Heat Shrink

Cable Ties

Screws + Dril Bit

Wiring Diagram

Features

Bluetooth Smart enabled

Any Bluetooth enabled smart phone, tablet or other device can be used to monitor, to change settings and to update the charger when new software features become available.



Fully programmable

- Battery charge algorithm (configurable) or fixed output.

- Smart alternator compatibility: engine running detection mechanism.

Adaptive 3-stage charge algorithm: bulk - absorption - float

- For lead acid batteries it is important that during shallow discharges the absorption time is kept short in order to prevent overcharging of the battery. After a deep discharge the absorption time is automatically increased to make sure that the battery is completely recharged.

- For lithium batteries absorption time is fixed, default 2 hours.

- Alternatively, a fixed output voltage can be chosen.



Remote on-off

A remote on/off switch or relay contact can be connected to a two-pole connector. Alternatively, the H terminal (right) of the two-pole connector can be switched to battery plus, or the L terminal (left) of the two pole connector can be switched to battery minus (or the chassis of a vehicle, for example).



All models are short circuit proof and can be paralleled to increase output current

An unlimited number of units can be connected in parallel.



High temperature protected

The output current will reduce at high ambient temperature.



IP43 protection

When installed with the screw terminals oriented downwards.



Screw terminals

No special tools needed for installation.



Input fuse (not replaceable)



Technical Specification



Input voltage range

10-17V

Under voltage shut down

7V

Under voltage restart

7,5V

Nominal output voltage

12,2V

Output voltage adjust range

10-15V

Output voltage tolerance

+/- 0,2V

Output noise

2mV rms

Cont. output current at nominal output voltage and 40°C

30A

Maximum output current (10 s) at nominal output voltage minus 20%

40A

Short circuit output current

60A

Cont. output power at 25°C

430W

Cont. output power at 40°C

360W

Efficiency

87%

Off load current

< 80mA

Galvanic isolation

200V dc between input, output and case

Operating temperature range

-20 to +55°C (derate 3% per °C above 40°C)

Humidity

Max. 95% non-condensing

DC connection

Screw terminals

Maximum cable cross-section

16 mm² (AWG6)

Height

130 mm

Width

186 mm

Depth

80 mm

Weight

1.8 Kg

Warranty

5 Years